| 05-02-10 |
| Alvenius will exhibit in Alpitec Bolzano 2010 (13th-15th of April) and SAM Grenoble 2010 (21st-23rd of April) |
| 28-12-09 |
| Updated reference list Snowmaking 2009 |
| 06-11-09 |
| Alvenius will exhibit at the Euro Mine Expo in Skellefteå, Sweden, 8th-10th of June 2010 |
Assembly without flame, or messy cutting oils and chips, and with a minimum of bolts, has great appeal for many users.
Alvenius pipe systems can be assembled with unskilled personnel and to that with a very short assembly time. The pipe systems require two bolts for each coupling (through 300 mm). Bolt hole alignment is not critical, as is the case with flanges.
The gaskets outer mating surface and the lips' inner mating surfaces are lightly greased with a lithium or silicon-based grease. The rubber gasket is slid onto one of the pipe ends.
Align the connecting pipe's end with a clearance of 2-3 mm. Slide the rubber gasket over the joint.
Fit the two halves of the coupling so that they enclose the gasket and the pipe ends.
Tighten the screws evenly and alternately.
